11
USER MANUAL
DCP-SRX
(e.g. DCP-MTX N to DCP-SRX 1).
6) If Ring Mode connection is required, connect HDBT OUT of the last DCP-SRX
to HDBT IN of the first DCP-MTX (e.g. DCP-SRX N to DCP-MTX 1).
2. Set up IP Sequencing for all the DCP-MTXs and DCP-SRXs.
• Option A: Using the MYTURN button of the first DCP-MTX (e.g. DCP-MTX 1)
a) Long press the MYTURN button of DCP-MTX 1 for 10 seconds;
b) The input LEDs (HDMI IN, DP IN and VGA IN) will flash twice, then
DCP-MTX 1 will start IP sequencing automatically and the rest DCP-
MTXs and DCP-SRXs will get its individual IP address according to
their sequence in the connection loop (for instance, if DCP-MTX 1 gets
192.168.1.121 (Default IP address of DCP-MTXs), then DCP-MTX 2 will
get 192.168.1.122.)
• Option B: Using Start Sequence button on Web UI.
a) Connect your PC to ETHERNET port of the first DCP-MTX (e.g. DCP-MTX
1).
b) Login Web UI through a web browser (Default IP address of DCP-MTXs
is192.168.1.121).
c) Go to Configuration > Device > Daisy-chain Sequence. Select Daisy-chain
quantity and click “Start Sequence” to allocate IP addressing to each DCP
device.
3. Connect source and display devices to DCP-MTXs.
4. Connect an HDMI display device to HDMI OUT of each DCP-SRX. If audio output is
required, connect an audio system to AUDIO OUT of DCP-SRX.
NOTE:
• Default IP address of DCP-SRX is 192.168.1.122, DCP-MTX is 192.168.121.
• The PC used to login Web UI of DCP should be set in the same network segment
as DCP devices, e.g. 192.168.1.x.
• To avoid IP addressing conflicts, please repeat Step 2 if any DCP-MTX or DCP-SRX
is reset, removed from and added to the connection.
• To make CEC control effective, please use CEC-enabled display devices.
• Quality CAT cables, e.g. Cat6, AWG23 or S/FTP cable, are highly recommended.
For more information about HDBaseT transmission cables, please visit: www.
hdbaset.org/cable.
