Amphenol H4 Series, Инструкция по эксплуатации

Страница: 15 / 19

H4
系列连接器安装手册
H4 SERIES
I
NSTRUCTION MANUAL
文件编号
(File Name) :WI-S037-ENG
SOP-001QF-07 REV.A Page 15 of 19
客户在现场安装时，可使用安费诺蓝色扳手
(H4
和
H4-H
使用
H4TW0001,Enlarge H4
使用
H4TW0004 )
组装连
接器，客户用机器组装连接器时，可使用安费诺专用连接器套筒进行组装
(H4
和
H4-H
使用
H4TTW100
，加大
H4
使用
H4TTW400)
如图
5.1.6
及图
5.1.7
。
Amphenol specified wrench tool (H4TW0001 for H4&H4-H and H4TW0004 for Enlarge H4) can be used in this step
or electric torque controlled wrench tool with as well as the Amphenol open-end back cap spanner (H4TTW100 for
H4&H4-H and H4TTW400 for Enlarge H4). See below picture 5.1.6 and 5.1.7.
图
5.1.6
图
5.1.7
Picture 5.1.6 Picture 5.1.7
5.1.3)
备注：
Notes
1> H4
及
H4-H
连接器线材外径要求为
ø4.5mm
到
ø7.8mm
，加大
H4
连接器线材外径要求为
ø7.6mm
到
ø9.3mm
。
The cable range of H4 and H4-H connector is from ø4.5mm to ø7.8mm, Enlarge H4 connector is from ø7.6mm
to ø9.3mm.
2>
适用
H4
及
H4-H
连接器导线的线芯数为
7
到
140
根
,
适用加大
H4
连接器导线的线芯数为
19
到
77
根。
The number of conductor strands for H4 and H4-H is from 7 to 140. The number of conductor strands for
Enlarge H4 is from 19 to 77.
3>
扭矩要求只针对太阳能线材。不同的线材组装完成后都需达到
IP68
及拉力测试要求（无端子状态下吊重
20Lb
，一分钟）。
These torque force apply to Amphenol PV cable only. The cable assembly should pass IP68 and Pullout test
(20Lb, 1Min, without contact) which H4, H4-H and Enlarge H4 PV connector assembled with different PV cable.
4>
线材线芯只能用铜线芯。
A statement that the conductor type is limited to copper wire only ( "Copper" or "CU" are acceptable).