Ampcontrol ABCM, Руководство пользователя

Страница: 5 / 26

ABCM CHARGER USER MANUAL
11/03/2020 9:25
Page 5 of 19
Ampcontrol Electronics Pty Ltd
– ABN 35 000 770 141
ABCM Battery Charger User Manual
MAG-212, Rev 5
– March/2020
1
SAFETY AND OTHER WARNINGS
For safety reasons, the ABCM Battery Charger must be installed, operated and serviced only by
competent personnel. Read and understand this instruction manual completely before installing,
operating or servicing this equipment. Failure to install or operate this instrument in accordance with the
instructions contained in this manual may create hazardous operating conditions.
1.1 Safe Use of Equipment
The equipment supplied has been manufactured according to the state of the art, and designed to
ensure a safe operation. The equipment may only be used within the design parameters. If there are any
signs of modification or damage to this equipment, it must not be used until it has been repaired and
deemed fit for purpose by the equipment
’s manufacturer or by an AS/NZS 3800 accredited workshop.
The instructions within this manual must be observed as an aid towards achieving maximum safety
during operation.
The owner/user is responsible for observing the following instructions:
1.1.1 Changes to Equipment
Changes in the design and modifications to the equipment are not permitted. Unauthorised changes
made to the hardware or operating firmware will void the manufacturer's warranty, and may
compromise the integrity of the system into which it is installed and other connected equipment.
1.1.2 Equipment Knowledge
Experience with, or understanding of, this equipment is essential for the safe installation and removal of
the equipment. Therefore, in case of a question on how to safely proceed, contact Ampcontrol
immediately.
1.1.3 Manual Handling
Precautions have been taken to ensure all equipment is safe to handle and free from sharp edges.
However care should always be taken when handling enclosures and gloves should be worn.
1.1.4 Installation
Correct operation and safety depend on the ABCM Battery Charger and associated equipment being
installed correctly. Mechanical and or electrical installation and maintenance of plant and equipment
must only be carried out by appropriately qualified personnel and must be tested thoroughly prior to
operation.
Mechanical Installation
–
After unpacking the crates and packages the battery charger must be
transported using appropriate lifting equipment to the intended installation area. The battery charger may
be supplied with or without the batteries and enclosure/s (depending on the client purchase order) but
these mechanical installation instructions should still serve as a general guide.
WARNING!
The lower cabinet must be firmly secured to the ground or its
support structure, and the upper cabinet must be firmly attached to
the lower cabinet using appropriate fasteners. This is essential to
maintain the structural integrity of the assembled cabinets.