
10
BP868F / UME-07-REV.2-08B13
PREPARATION
[Fig 1]
[Fig 3]
[Fig
[Fig 2]
3) Assemble Arm Rest
For better and more accurate blood pressure measurement, mount the arm rest supplied with the
machine.
4
) Paper Setting
Set the paper in the setup mode as in the picture on the right.
To enter the setup mode, press the STOP button.
①
While the power is on, press the printer cover indicated
area on the [Fig 1] to open the printer cover.
②
Pull up the lever on the left. [Fig 3]
③
Place the beginning of the roll into B as in Fig 3.
Make sure the data is printed on the outer surface
of the roll.
④
Press L/F button repeatedly until the paper comes
out through C. [Fig 4]
⑤
In case the paper is tiled or leaned to one side, set
the paper again.
⑥
When the paper comes out through C, put the shaft
into the roll and put it in place. [Fig 5]
⑦
Pull down the lever.
⑧
Put the beginning of the recording paper into the
⑨
groove of the cover to pull it toward the outside (D)
[Fig 6]
⑩
Place the cover and close.
<Attention>
• When you pull out the paper, pull up the lever first.
• If you do not pull down the lever, it will not print.
• Use thermal printing paper only (Length: 25 m, Breadth: 57.5 mm).
• Make sure the paper is clean and not crumpled.
• Do not pull the paper while printing.
• Store the paper in a well ventilated and dark place.