En-3
II. Attaching the receiver unit (Wiring pattern A)
1
2
Holder
(PCB)
Holder cover
Screw
1
Remove the screw.
2
Remove holder (PCB) from
holder cover.
1
Cut the projections in the areas
indicated with a
and
remove them.
(Be careful not to injure
yourself on the cut edges of
the holder cover.)
1
2
2
Screws (M4 x 20mm)
Wall or
ceiling
Hook
1
2
1
Affix the insulation to the
holder cover.
2
Attach the holder cover to the
wall or ceiling with the screws
(included with the standard
parts).
1
Reattach holder cover. (Make
sure that the hook on the
holder cover is caught on the
holder [PCB].)
2
Fix holder (PCB) by the screw.
7. WIRING
WARNING
Before starting work, make sure that power is not being supplied to the
•
indoor unit.
Always fasten the outside covering of the connection cord with the cord
•
clamp. (If the insulator is chafed, electric leakage may occur.)
CAUTION
Do not touch the PCB or PCB parts of indoor unit directly with your
•
hands.
When fixing the wiring, be careful to avoid touching the edge of the
•
indoor unit or the control box.
Install the remote controller wires so as not to be direct touched with
•
your hand.
Make sure to use and roll an insulation tube of more than 1 mm thick
•
at the connection point of the receiver unit wire A and the receiver unit
wire B.
Insulation tube
CONNECT
Tape
6.1. Select the wiring pattern
Pattern A From the top of the receiver unit: No additional work is
necessary.
Pattern B From behind the receiver unit: Perform the following procedure
to route the wiring behind the receiver unit.
1
2
Holder
(PCB)
Holder cover
Screw
1
1
Remove the screw.
2
Remove holder (PCB) from
holder cover.
1
Route the wiring as shown
in the figure.
2
1
Hook
Holder cover
Screw
1
Reattach holder cover. (Make sure that the hook on the holder
cover is caught on the holder [PCB].)
2
Fix holder (PCB) by the screw.
6.2. Select the installation method
Method 1 Receiver unit embedded in a wall or ceiling:
Refer to “I. Embedding the receiver unit.”
Method 2 Receiver unit attached to a wall or ceiling:
Refer to “II. Attaching the receiver unit.”
I. Embedding the receiver unit (Wiring pattern A or B)
60mm - 64mm
120mm - 140mm
Screws (M4 x 20mm)
1
2
2
Wall or ceiling
1
Make a hole in the wall or
ceiling.
(Depth: 25mm or more)
1
Affix the insulation to the
holder cover.
2
Attach the holder cover and
bracket (cover) to the wall
or ceiling with the screws
(included with the standard
parts).
Cover
Bracket
(cover)
Cover
1
1
2
1
Install the cover.
Hook the 2 projections on the top of the cover onto the bracket
(cover), and then hook the projection on the bottom of the cover
onto the bracket (cover).
2
Make sure that there is no gap between the cover and the wall
or ceiling.
3
4
3
3
1
1
2
1
2
2
9378626041-03_IM.indb 3
14/5/2555 9:07:11
AMP Air Conditioning
www.ampair.co.uk | [email protected]
