Sampling by sound or pressure increment is
not supported in burst mode.
set sound inc <value>
Set sound velocity increment.
set pressure inc <value>
Set pressure increment.
set <detection parameter> threshold <value>
Set the threshold for water detection to begin
automatic logging. Valid detection parameters
are “conduct”, “sound”, and “pressure”. By
default pressure is set to 99999.99 and it is
not recommended to detect water by
pressure unless there are no sound velocity
or conductivity sensors installed.
Note: This is a secure command.
5.2 Monitor Configurations and commands
Command
Description
monitor
Start streaming data on the user terminal. Hit
<enter>
to exit monitor, hit
<enter>
three
times to exit monitor when in robust mode.
mmonitor
Start streaming data in AMLx format.
scan
Print a single line of the latest sensor data.
mscan
Print a single line of the latest sensor data in
AMLx format.
set monitor robust [y | n]
Enable/disable robust monitor mode. When
enabled, monitoring is halted via 3 carriage
returns.
When disabled, a single carriage return will
halt monitoring.
set monitor auto <seconds>
Monitoring will begin automatically after an
interval of inactivity. Setting to “0” disables
auto monitor.
Min value: 5
This command applies only to monitoring via
serial connection
AML Oceanographic Ltd.
23/38
