5
Speaker settings
Check model numbers
The APU-RSi are compatible with four
groups of Amina speaker models, and
the APU-RSiC are compatible with two
groups. These are shown in the table
below.
Group
Compatible models
APU-RSi 8/16
1
iQ1, iQ2
3
iQ3, AIW350iN-S200,
MobiusDual
5
Mobius5
7
N/A
APU-RSiC 8/16
1
N/A
3
N/A
5
Edge5
7
Edge7, Mobius7
NOTE: The factory setting for all jumpers
is Group 1. If all connected
speaker models are listed in
Group 1 of the table, it will not be
necessary to change any settings.
If not changed from Group 1,
higher perfoming loudspeakers
will have their performance
characteristics limited.
• Before changing any settings, make
a note of which speaker model will
be connected to each channel of the
APU-RSi or the APU-RSiC.
Cautions when changing
speaker settings
Ensure that each channel is
correctly set to match the
connected speaker before use.
Failure to do so could result in
speaker damage.
• The APU-RS8i, APU-RS16i, APU-RS8iC
and APU-RS16iC are low voltage,
passive devices, however ALWAYS
disconnect them from all speakers
and amplifiers before changing
speaker settings.
• Ensure that jumpers are fully pushed
down onto their pins when changing
settings.
• Only fit one jumper for each channel.
• Ensure the lid is securely fitted to the
product after changing settings.
• Only remove and replace the lid
fixing screws by hand. Always use the
correct tool and do not over tighten.
