Model
SE578A
Service
Troubleshooting
Parts
5. Swing Arms
Rev.
1
2
3
4
Procedures：
1.
There are 0.05mm~0.07 mm tolerances
with the parts for the concern of easy
assembly by the user and it is normal
with slight play. Noises might be
caused due to these tolerances after
certain time of usage. It is
recommended to add crease or thick
lubricant on ψ25x296L console mast
shaft for the handle bar. If noises come
from 6005 bearing, replace the bearing.
2.
If handlebar button does not function,
then tear off the sticker and use
Phillips head screw driver to release
M5x20mm Flat Head Socket Screw
which secures the handlebar button, as
shown in figure 1 and 2. Check and
make sure that handlebar button is
connected with lower cable properly,
as shown in figure 3.
3.
Check and make sure that upper and
lower handle wires are connected
properly and free from damage, as
shown in figure 4.
