amiad AMF-370K-S, Инструкция по установке и эксплуатации

Страница: 4 / 86

AMF 370K -S 02.2018 Page 4 of 86
1. Introduction & How to use this manual
1.1. Using this manual
This manual describes the end-user operation procedures of Amiad’s AMF 370K-S filter. For broadening the user’s general
knowledge a general description of Amiad’s micro-fiber filtration technology and some basic information on installation is
also provided.
This manual does not replace the Technicians’ Installation, Service and Maintenance Manuals and it should not be used
for any task other than the regular operation of the filter.
Before operating the filter please read this manual carefully. Make sure that:

You are familiar with the safety instructions
(Chapter 1.2)

You understand the basics of the Micro-fiber filtration technology
(Chapter 1.3)

You know how to use the control panel
(Chapter 3)
1.2. Safety instructions
1.2.1 General

Amiad filtration products always operate as components in a larger system. It is essential for the system designers, installers and
operators to comply with all the relevant safety standards.

Prior to installation, operation, maintenance or any other type of action carried out on the filter, read carefully the safety, installation
and operation instructions.

During installation, operation or maintenance of the filter all conventional safety instructions should be observed in order to avoid
danger to the workers, the public or to property in the vicinity.

Please note: The filter enters into a flushing mode automatically, without prior warning.

No change or modification to the equipment is permitted without a written notification given in advance by the manufacturer or by its
representative, on the manufacturer’s behalf.

Always observe standard safety instructions and good engineering practices whilst working in the filter’s vicinity.

Use the filter only for its intended use as designed by Amiad, any misuse of the filter may lead to undesired damage and may affect your
warranty coverage. Please consult with Amiad prior to any non-regular use of this equipment.
1.2.2 Installation
General

Install the filter according to the detailed Installation Instructions provided with the filter by the manufacturer and according to the
description given in this manual.

Make sure to leave enough clearance so as to enable easy access for future treatments and safe maintenance operations.

The user should arrange suitable lighting at the area of the filter to enable good visibility and safe maintenance.

The user should arrange suitable platforms, ladders and safety barriers to enable easy and safe access to the filter without climbing on
pipes and other equipment. The user should verify that any platform, barrier, ladder or other such equipment is built, installed and used
in accordance with the relevant local authorized standards.

Check and re-tighten all bolts during commissioning and after the first week of operation.

Use only appropriate standard tools and equipment operated by qualified operators when installing, operating and maintaining the filter.

When installation is required in hazardous environment sites, underground or high above ground, make sure that the site design and the
auxiliary equipment are appropriate and that installation procedures are carried out in accordance with the relevant standards and
regulations.

Ensure walking areas about the installation are slip free when wet.