35
To lower vehicle
1. Be sure clear of around and under the lift, only leaving operator in lift area;
2. Push button
UP
to raise the vehicle slightly, and then release the safety device, lower
vehicle by pushing release handle.
3. Open the arms and position them to the shortest length;
4. Drive away the vehicle.
5. Turn off the power.
Note: In order to extend the service life of the cylinder and seals, raise the machine to
top at least once a day
VII. MAINTENANCE SCHEDULE
Monthly:
1. Re-torque the anchor bolts with 150 N∙M;
2. Check all connectors, bolts and pins to insure proper mounting;
3. Lubricate cable with lubricant;
4. Make a visual inspection of all hydraulic hoses/lines for possible wear or leakage;
5. Check Safety device and make sure proper condition;
6. Lubricate all Rollers and Pins with 90wt. Gear oil or equivalent;
Note: All anchor bolts should take full torque. If any of the bolts is malfunction for any
reason, DO NOT use the lift until the bolt has been replaced.
Every six months:
1. Make a visual inspection of all moving parts for possible wear, interference or
damage.
2. Check and adjust as necessary, equalizer tension of the cables to insure level lifting.
3. Check columns for plumbness.
4. Check Rubber Pads and replace as necessary.
5. Check Safety device and make sure in proper condition.
Oil cylinder maintenance:
In order to extend the service life of the oil cylinder, please operate according to
the following requirements.
1. Recommend to use N46 anti-wear hydraulic oil.
2. The hydraulic oil of the lifts should be replaced regularly during using. Replace the
hydraulic oil 3 months after the first installation, Replace the hydraulic oil once a year
afterwards.
3. Make at least one full trip raising and lowering per day. For exhausting the air from
the system, which could effectively avoid the corrosion of the cylinder and damage to
the seals caused by presence of air or water in the system.
4.
Protect the outer surface of the oil cylinder’s piston rod from bumping and scratching,
and timely clean up the debris on the oil cylinder dust-ring and the piston rod.
Содержание OH-9
