ES-505
1-85
Released: 01/2018
E-mail: [email protected]; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
E - STANDARD MACHINE ADJUSTMENT
12.2. MODIFICATION OF CUTTING STEELS SURFACE
Neat buttonhole cut in fabric can be achieved only if the cutting
pressure is the same along the whole buttonhole length.
Damaged cutting steels can be refined on their surface by
grinding but only 1 mm of the material thickness. Modified block
can be placed in the machine again.
Once the cutting steel is installed, check the cut with the
Immediate cutting activation button
3
placed on the
control box.
If the fabric is not cut, it is necessary to move the cutting sensor
2
upwards (1 mm max).
Procedure
:
Loosen the screw
1
and move the sensor
2
in required
direction as in the picture.
Tighten the screw
2
to secure the position of the sensor
1
.
Check the correct adjustment by repeated pressing of Immediate
cutting activation button
3
.
12.3. CUTTING WITH SLIDING CUTTING STEEL (ULTRAFLEX)
It is necessary to change the cutting knife or
cutting steel if the shape of the buttonhole cut
is changed.
Procedure
:
Loosen the screew
1
and replace the cutting
knife
2
in the cutting head
3
.
Loosen the screew
4
and change the cutting
steel
5
in cutting block
6
.
CAUTION
!
At this model it is not necessary to replace the cutting steel if a knife type is changed. The cutting steel is heat-
treated in a way to provide higher machine flexibility.
WARNING
!
At this model, cutting steels must not be sharpened because the quality of the buttonhole cut would go worse! If the
cutting steel seems to be worn out (see chapter E 12.1.), change it with new one!
