AMF ES-505, Руководство по эксплуатации и ремонту

Страница: 80 / 146

ES-505
1-66
Released: 01/2018
E-mail: service@amfreece.cz; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
E - STANDARD MACHINE ADJUSTMENT
Starting sewing cycle depends on the parameter 3 . If the left pedal is only active, you will operate individual steps
with the left pedal . If both pedals are active, take the following steps: depress the left pedal to lower the clamp
feet. Then depress the right pedal to move the bedplate forward. Use the left pedal to operate the stepping. To
deactivate stepping in any moment of the sewing cycle, depress the stepping button 7 again.
Note :
While the stepping function is active, the electronic servo-driver position hold is deactivated and can be turned
manually.
Slight bedplate movements while stepping
This function enables to move the bedplate as if a buttonhole is being sewn. The servo-driver is not on, and it is
blocked electronically (the hand wheel cannot turn). The function is active if the button
8
is pressed. Once
the button is pressed, the bedplate moves onto another stitch. The function is deactivated with the STOP emergency
button.
Starting sewing sequence depends on the parameter 4 . If the left pedal is only active, depress the left pedal. If the
right pedal is active as well – see – picture/detail 4 . Depress both pedals. The bedplate moves once the button 8
is pressed.
Note :
If you wish to move the hand wheel, first you need to activate stepping , mode then start sequence and then
move the bedplate by pushing the button .
9
Additing/removing eye start stitches
Press the button
9
to add or remove two stitches at the beginning of sewing.
10 Front position bed plate speed
Pressing the button 10 can adjust bedplate speed for front position of table. This parameter is used for LTT model
only. Range is 30 rpm - 150 rpm.
2.6. SELECTION OF MODEL AND MACHINE ACCESSORIES
2.6.1. SELECTION OF STANDARD MODEL AND MACHINE ACCESSORIES
This screen enables to select a machine model and its accessories. Pressing the button 1 on the main service
screen enters the screen of model selection and machine accessories. The screen falls under the protection level III
and is protected by a password; see chapter E 2.2 .
Pressing buttons
2
,
3
,
4
,
5
,
6
, 7 and
8
enables to select a required machine accessories and model.
CAUTION !
When changing machine accessories it is necessary to make the change in the machine software by selecting
accessories. Otherwise the machine can get damaged!!!