ES-505
1-8
Released: 01/2018
E-mail: [email protected]; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
A - INTRODUCTION
4.2. ULTRAFLEX MODEL
Elektronic apparel buttonhole machine with sliding cutting steel
enables sewing buttonholes withing the range of 13- 30 mm and
wits the cut 6 - 30 mm without the change the cutting steel. This
device is called ULTRAFLEX (formerly know as ACL).
ULTRAFLEX model is supplied in LTT version - all threads
trimming - unless other version specified. AF version - without
trimming all threads - is available.
To run the machine in ULTRAFLEX mode, follow the section
D
2.6
.
4.2.1.
Models of machines with ULTRAFLEX:
a) LTT Ultraflex - LP1:
Uses the range of sewing
13 - 30
mm. It enables cutting only
the buttonhole along its all length, and also cutting only the eye
section or partically the straight part of the buttonhole within
8 - 25
mm.
The Ultraflex device can be used to sew jakets.
b) LTT Ultraflex - LP2:
Uses the range of sewing
13 - 38
mm. It enables cutting only
the buttonhole along its all length, and also cutting only the eye
section or partically the straight part of the buttonhole within
24
- 33
mm.
The Ultraflex device can be used to sew jakets.
For automatically sewn buttonholes on jacket front, there is an optical sensor
1
(seee section A 8), with hepls the machine operator work faster. It is
difficult to install the sensor and therefore necessary to remember to order it
with the machine.
Later assembly at the customer is not possible!!
