Ametek Sorensen XEL 15-5, Руководство по эксплуатации

Страница: 41 / 186

LSE<n> <nrf> Set the value of LSE<n>, Limit Event Status Enable Register <n>, to <nrf>
LSE<n>? Return the value of LSE<n>, Limit Event Status Enable Register <n> - response
is <nr1><rmt>
SAV<n> <nrf> Save the current set-up of output <n> to the set-up store specified by <nrf>
where <nrf> can be 0-9.
RCL<n> <nrf> Recall a set up for output <n> from the set-up store specified by <nrf> where
<nrf> can be 0-9.
RATIO <nrf> Set the ratio of output 2 (slave) to output 1 (master) in tracking mode to <nrf>,
where <nrf> is the ratio in percent (0 to 100).
RATIO? Query the ratio of output 2 (slave) to output 1 (master) in tracking mode. The
response is <nrf>, where <nrf> is the ratio in percent (0 to 100).
System and Status Commands
*CLS Clear Status. Clears the Status structure. This indirectly clears the Status Byte
Register.
EER?
Query and clear Execution Error Register. The response format is nr1<rmt>.
*ESE <nrf> Set the Standard Event Status Enable Register to the value of <nrf>
*ESE? Returns the value in the Standard Event Status Enable Register in <nr1> numeric
format. The syntax of the response is <nr1><rmt>
*ESR? Returns the value in the Standard Event Status Register in <nr1> numeric format.
The register is then cleared. The response is <nr1><rmt>. See Status Reporting
section for details.
*IST? Returns ist local message as defined by IEEE Std. 488.2. The syntax of the
response is 0<rmt>, if the local message is false, or 1<rmt>, if the local message
is true.
*OPC Sets the Operation Complete bit (bit 0) in the Standard Event Status Register.
This will happen immediately the command is executed because of the
sequential nature of all operations.
*OPC? Query Operation Complete status. The response is always 1<rmt> and will be
available immediately the command is executed because all commands are
sequential.
*PRE <nrf> Set the Parallel Poll Enable Register to the value <nrf>.
*PRE? Returns the value in the Parallel Poll Enable Register in <nr1> numeric format.
The syntax of the response is <nr1><rmt>
QER? Query and clear Query Error Register. The response format is nr1<rmt>
*RST Resets the instrument to the remote control default settings with the exception of
all remote interface settings and stored set-ups. (see Remote Operation
Defaults paragraph in the Remote Interface Operation section)
*SRE <nrf> Set the Service Request Enable Register to <nrf>.
*SRE? Returns the value of the Service Request Enable Register in <nr1> numeric
format. The syntax of the response is<nr1><rmt>
*STB? Returns the value of the Status Byte Register in <nr1> numeric format. The
syntax of the response is<nr1><rmt>
*WAI Wait for Operation Complete true. As all commands are completely executed
before the next is started this command takes no additional action.
37