Ametek ORTEC digiBASE, Руководство пользователя

Страница: 11 / 60

931003E / 0620 2. GETTING STARTED
Figure 3
. Choose ‘USB-based instruments’
2.3. Software and Hardware Installation
Installing the digiBASE and the MAESTRO MCA Emulation Software takes just four easy
steps:
1) Install the accompanying version of the C
ONNECTIONS
Driver Update Kit (p/n 797230),
being sure to select
USB-based instruments
on the Instrument Families screen.
2) Install the accompanying version of MAESTRO (A65-BW).
3) Connect the digiBASE to the USB port on the computer.
4) Run the MCB Configuration program to establish communication with your MCBs.
2.3.1. Step 1: Install the C
ONNECTIONS
Driver Update Kit
The first step is to install the accom
panying version of the C
ONNECTIONS
Driver Update Kit. This product
must be installed before MAESTRO
can be installed. On the Instrument
Families page, be sure to mark the
USB-based instruments checkbox,
as shown in Fig. 3. Otherwise the
digiBASE will not be able to com-
municate with the computer and
MAESTRO.
If you also have other types of MCBs
attached to this computer, refer to the
installation instructions in the corre-
sponding hardware manuals. Note that
you can install device drivers for other
types of instruments later, as described
in the C
ONNECTIONS
Driver Update
Kit instructions.
2.3.2. Step 2: Install MAESTRO
Install the accompanying copy of MAESTRO according to the instructions in its User’s Manual .
5