Portable Thermometers
User Guide
Cyclops L
9 - 4
10) Aim the thermometer through the viewing window/port at the target
and focus the graticule onto the area under observation. Check that the
graticule is fully filled by the target, re-position if necessary
11) Press the trigger to start measurement. The main display and eyepiece
display are updated with the reading.
12) Release the trigger to stop measurement and freeze the last recorded
value on the main display.
9.3 Operation (Example 3: route mode)
1) Switch the thermometer on via the On/Off switch. The initialisation screen
will appear and, after a few seconds, the screen will change to show the
measurement mode display.
2) Check the battery status, ensure that there is sufficient battery life
remaining.
3) If routes have not already been downloaded to the thermometer, connect
to the
Logger Software
and follow the steps under
Route Management
in its user guide to do this.
4) Set the thermometer into route mode and select a route by going into
Menu Mode
, opening the
Trigger Menu
and selecting
Route Mode
, then
select a route saved in memory by selecting its route number (1,2,3 or 4)
and select whether you want the route location to auto-increment along
the route.
5) When in
Measurement Mode
, the side display will now show a list
of locations along the selected route, these can be navigated by using
the up and down keys. Three locations and their measurements will be
displayed, the middle one is the currently selected location and is where
any measurements will be stored.
6) Press the trigger to start measurement. The currently selected location on
the side display and the eyepiece display are updated.
7) Release the trigger to stop measurement and freeze the last recorded
value on the main display.
8) This measurement will be stored when any of the up, down or enter keys
are pressed.
9) The data stored on a route is saved on the Cyclops for download at a later
time; this is done from the logger software using the
Download Routes
function.
