Installation Guide
Thermal Imaging Camera
NIR-656 / NIR-2K
1
This Installation Guide gives instructions on how to the install the AMETEK Land
NIR-656 / NIR-2K Fixed Thermal Imaging System. The system is operated from
IMAGEPro
or
IMAGEViewer
software, both of which are available from AMETEK Land.
These instructions are provided as a series of simple installation diagrams, covering
the installation of the NIR-656 / NIR-2K thermal imaging camera and its mountings,
accessories and services.
The equipment must be used, maintained and serviced by properly trained personnel,
capable of following the procedures given in these instructions. Safety may be impaired
if the system is not used as indicated.
It is important to check the equipment with which you have been supplied and then
read these instructions thoroughly before proceeding with operation.
There are two basic installed configurations covered by this guide.
Imager
Optional
Purge
Blower
Optional
Water
Cooling
IMAGEPro or
IMAGEViewer
Optional
Remote
Computer
Optional
Input/Output
Signals
Optional
Protection Jacket /
Back Cap / Air Purge
Control Computer Installation
PSU Installation
Imager
Optional
Purge
Blower
Optional
Water
Cooling
PSU
Optional
Protection Jacket /
Back Cap / Air Purge
Capable of providing 12 to 30V dc
Max 1% ripple
Voltage outputs isolated from local ground.
INTRODUCTION
1
