Installation Guide
Thermal Imaging Camera
NIR-656 / NIR-2K
8
If the thermal imager is to be used in conjunction with a protection jacket and air
purge, refer to the installation guides provided with those accessories.
If the thermal imager is to be installed in a location where the ambient temperature
is within the ranges specified for the thermal imager, and no air purging is required to
keep the lens clean, the thermal imager can be mounted using the two tapped holes on
the mounting pad. Either hole can be used for direct tripod mounting.
A swivel ball mounting (S4 - B) is available from Land infrared. This mounting accessory
enables you to easily adjust the thermal imager's line of sight.
3.1 Fields of view
See also Field of View Diagram (Fig. 2-1).
Two fields of view are available:
•
16 ° x 12 °
•
48 ° x 36 °
Fig. 3-4 Thermal imager field of view
Ensure that the thermal imager has
an unobstructed view of the target area
Overall field
of view (vertical)
3.2 Thermal Imager installation dimensions
Fig. 3-5 Thermal Imager installation dimensions
Allow approx. 300mm/12in for cable access
80mm/3.2in
11
4m
m
/4
.5
in
Mounting Pad: 2 holes, ¼in BSW,
7mm/0.3in deep on 25mm/0.98in centres
