American Water Heater PowerVent, Инструкция по использованию и уходу

Страница: 20 / 36

Installation Checklist
A. Water Heater Location
B. Water Supply
C. Gas Supply
D. Relief Valve
E. Venting
❑ Close to area of vent.
❑ Indoors and protected from freezing
temperatures.
❑ Proper clearance from combustible surfaces
observed and water heater not installed on
carpeted floor.
❑ Sufficient fresh air supply for proper
operation of water heater.
❑ Air supply free of corrosive elements and
flammable vapors.
❑ Provisions made to protect area from water
damage.
❑ Sufficient room to service heater.
❑ Combustible materials, such as clothing,
cleaning materials, rags, etc. clear of the
base of the heater.
❑ Clearances of 1” from combustion air
inlet openings observed
❑ Flammable vapor sensor is not blocked.
❑
Water heater completely filled with water.
❑
Air purged from water heater and piping.
❑
Water connections tight and free of leaks.
❑
Gas line equipped with shut-off valve, union
and sediment trap.
❑ Approved pipe joint compound used.
❑
Soap and water solution used to check all
connections and fittings for possible gas
leak.
❑
Gas Company inspected installation (if
required).
❑ Temperature and Pressure Relief Valve
properly installed and discharge line run to
open drain.
❑ Discharge line protected from freezing.
❑
Heater vented separately from all other
appliances.
❑ Flue baffle properly hung in top of heater’s
flue.
❑
Blower assembly properly installed.
❑ Proper materials and techniques used in vent
assembly.
❑
Vent pipe properly secured to blower housing.
❑ Vent pipe supported at required intervals.
❑
Appropriate minimum clearances observed.
❑ Precautions taken to prevent moisture damage
around vent termination.
❑
Vapors from vent pipe cement and primer
have dissipated prior to applying electrical
power.
F. Wiring
❑ Correct power supply (120 V).
❑ Electrical connections tight.
❑
Heater properly grounded and proper polarity
observed.
20