8
1.
Remove AERATOR HOUSING
(1)
with KEY supplied
with faucet.
3.
Remove AERATOR
(2)
from HOUSING
(1)
.
2.
Clean the AERATOR SCREENS
(3)
with a old tooth
brush to remove dirt.
4.
Rinse Clean with water. Reassemble and install into
spout end. Be sure black seal washer is in place.
HOW TO CLEAN AND REMOVE
THE AERATOR; Fig. 5
5
2
3
Fig.5
1.
Remove ENCLOSURE COVER.
2.
Close SUPPLY STOP
(1)
with 4mm Hex wrench.
Note: Keep water flowing out of faucet while shutting off.
3.
Unthread STRAINER
(2)
using a 7/16" socket.
4.
Pull out the STRAINER
(2)
and clean with an old
toothbrush. Rinse thoroughly with water.
5.
Install the STRAINER
(2)
back in its place and
tighten with a 7/16" socket.
Caution: do not over tighten strainer.
Note: It is recommended to clean strainer every 6
months.
6.
Open SUPPLY STOP
(1)
with 4mm Hex wrench.
7.
Replace ENCLOSURE COVER. Tighten cover
screws firmly.
HOW TO CLEAN FILTER; Fig. 4
4
Fig.4
CAUTION
Before opening ENCLOSURE
disconnect AC power supply.
1
Fig.5
HOW TO CONVERT RIGID GOOSE
NECK SPOUT TO SWING SPOUT
Fig. 6
The GN SPOUT is shipped from the factory as a
rigid assembly. To convert the GN SPOUT into a
SWING SPOUT proceed as follows:
1.
Remove SET SCREW
(1)
from back of GN SPOUT
(2)
with a flat blade screwdriver. Fig. 6.
2.
Install SWIVEL SET SCREW
(3)
into opening in the
GN SPOUT
(2)
.
SWIVEL SET SCREW
(3)
is found in
hardware bag within product box.
6
Fig.6
1
2
3
(USE SHORT
SET SCREW
FOR SWIVEL
SPOUT)
M 9 6 8 8 0 9
Rev. 1. 7
3
1
2
7/16" SOCKET
CLEAN
SCREENS
4mm HEX WRENCH
