American Megatrends Baby Voyager 80486, Руководство пользователя

Страница: 72 / 83

Chapter 4 - AMIBIOS Features
66
Hard Disk Utility Error Messages,
Continued
Operation Errors
Message Explanation
Address Mark Not
Found The address mark (initial address) on the hard disk
could not be found.
Attachment Failed to
Respond No response has been received from the hard disk
drive.
Bad ECC on Disk
Read When the hard disk drive utility writes to the disk, it
also calculates an ECC (Error Correction Code)
value for the data being written. This ECC value is
written to the drive and then read back. The value
read back is different from the one calculated.
Bad Sector Flag
Detected An operation was performed on a sector that has
been flagged as bad.
Controller Has
Failed A diagnostic command was issued to the controller
failed.
Drive Not Ready An operation on the hard disk drive has timed out.
The hard disk drive utility has waited beyond a preset
specified time limit.
Drive Parameter
Activity Failed A reset command was sent to the controller followed
by drive parameters. Using these parameters, the
controller did not get a response from the hard disk.
Make sure the drive type is correct.
ECC Corrected Data
Error The ECC value (explained above) read from the disk
is not the same value which was written to the disk.
The data is not correct. An attempt was made to
correct the data, but the ECC value is not corrected.
Requested Sector
Not Found The requested sector could not be found.
Reset Failed The reset command did not properly reset the hard
disk.
Seek Operation
Failed A seek command failed. A seek operation is the act
of finding a particular sector on the hard disk.
Undefined Error -
Command Aborted An unidentifiable error condition occurred.
Write Fault on
Selected Drive A write fault occurred during the write operation on
the hard disk drive.