American Hometec AHQ-TB32, Инструкция по установке и эксплуатации

Страница: 12 / 56

12
START UP
1. Open water inlet and outlet. Turn on water and let water flow through
unit for one to two minutes and double check to ensure there are no leaks.
CAUTION: DO NOT OPERATE UNIT DRY.
2. If no leaks are found, turn on the power to unit at breaker.
3. Turn on the water heater power switch located on the control panel on
the front of the unit.
FOR REFERENCE: Temperature for bathroom sink is typically set to 98
o
F / 37
o
C and for kitchen is typically
set to 110
o
F / 43
o
C. Adjust temperature to
meet your comfort needs. However, temperature
should not exceed 125
o
F / 52
o
C due to possibility of scalding.
4.
Menue navigation/Set temperature to display Celsius or Farenheit.
AHQ-TB32
LED display shows actual outlet water temperature
LED lights shows
℃
or
℉
(Factory Default Temperature is 110
℉
)
LED display shows shower or high water usage
UP and DOWN buttons for adjusting water temperature1
℃
(2
℉
) or timer
setting 1minute by up or down each time. Up/down temperature twice per
second or Increase/Decrease timer setting 10minutes when holding 2 seconds.
Temperature range is 35
℃
(95
℉
) to 52
℃
(125
℉
),Timer range is 5minutes to
2hours.
POWER button for turning heater on or off. When heater is powered on, unit is
on standby until there is a hot water demand. Unit will heat water whenever hot
water faucet is turned on and incoming water temperature is lower than
125 F. If the heater will not be in use for a long time (such as during vacation), this
POWER button is recommended to be turned off. Holding the button 5 seconds
and more can switching between
℃
/
℉
display.
LED display shows water heating procedure
LED display shows running time or show the timer
Timer button is setting time or show the accumulated time. Holding the button
5 seconds can switch between timer / accumulated time function (Factory
Default is accumulated time function)