Intellex
®
Digital Video Management System Installation and Operating Instructions
15
Installing the Intellex Unit
MORE>>>
INSTALLING THE
INTELLEX UNIT
Select a location for the unit that is clean and dry and where
temperature and humidity extremes do not exceed the product
specifications (see
). Failure to do so can
result in equipment failure and loss of warranty protection.
Make sure the location has stable AC power for the unit. Protect
the unit against severe power fluctuations by installing surge
protection devices on all power cables.
Required Connections
Cameras In
CAUTION: Protect the unit against lightning. If a portion of a
cable is installed outside of a building, the entire
cable is vulnerable to lightning. Therefore, install
surge protection devices on all vulnerable cables.
Connect the video output of each camera or other composite
video source to its corresponding
Camera In
connector (the left
of each pair of BNC connectors). To use the passive loop through
feature, see
Monitor
The monitor displays live and recorded cameras, as well as
system configuration and status information.
To connect the monitor:
1.
Disconnect both ribbon cables from connectors 23 and 25 on
the rear panel (see
2.
Connect the VGA cable from an SVGA monitor to the
Monitor
connector.
3.
Reconnect both ribbon cables to connectors 23 and 25 on the
rear panel.
Power Setting
CAUTION: Before connecting power, set the voltage switch
to the correct voltage (“115” or “230”).
Switch the power supply to the correct input voltage setting: 115
or 230 volts.
Power In
CAUTION: You may want to install power line conditioning
equipment to protect the unit against severe power
fluctuations.
CAUTION: Do not apply power until you have connected all
optional items.