American Dryer Corp. AD-236, Руководство по установке

Страница: 30 / 48

26 American Dryer Corp. 113047 - 21
SECTION IV
OPERATING INSTRUCTIONS
A. STARTING THE DRYER
The dryer is available for use when the applicable (top or bottom basket [tumbler]) microprocessor controller
(computer) light emitting diode (L.E.D.) display reads the amount needed to start the dryer (i.e., “25”). Once the
load has been put into the dryer and the main door is closed, start the dryer as follows:
1. Insert the proper number of coins into the coin acceptor. Once the correct “Amount To Start” has been
inserted, the L.E.D. display will read “PUSH.”
2. Determine fabric setting (heat selection) - Setting/selecting “HI TEMP” is the high temperature range,
“PERM PRESS” is the medium temperature range, and “LO TEMP” is the low temperature range.
Once the fabric temperature setting (heat selection) has been determined, start the dryer by pressing that
setting key.
3. The dryer will now start, and the L.E.D. display will read the setting and the time vended (i.e., “LO 10”).
4. The cycle time will count down until the drying and cooling cycles are completed.
5. Upon completion of the drying and cooling cycles, the dryer will shut off, the tone (buzzer) will sound for
5-seconds, and the L.E.D. display will read “donE.”
NOTE: If the Anti-Wrinkle program is active, the L.E.D. display will remain reading “donE,” and the
microprocessor controller (computer) will proceed through the Anti-Wrinkle program until the
maximum “Active Guard Time” has expired or until the main door is opened, whichever comes
first.
NOTE: If the Anti-Wrinkle program is not active or in use, the L.E.D. display will read “donE” until
the main door is opened, at which time the L.E.D. display will read “FILL” and/or the
“Amount To Start.”
a. Notes
1) The dryer basket (tumbler) can be stopped at any time by opening the main door. To restart dryer,
shut the main door and press desired setting.