©American Audio® - www.americanaudio.eu
ELX Series
User Manual Page 19
2.
Slide the cable tension clip (D) and the Speakon coupler (E) through the
cable end.
See
Figure 9
.
3.
Insert each wire with the brass fittings into the top of appropriate slot of the
connector insert (B) as shown in
Figures 9 and 10
. Use a 1.5-mm Allen key to
tighten the connection.
See
Figure 10
.
4.
Be sure to properly match the positive (+) and negative (–) leads of each
wire.
See
Figure 11
.
5.
Slide the connector insert (B) into the connector housing (A), making sure that the large notch on the outer edge of the insert lines up with
the large groove on the inside of the connector housing. The insert should slide easily through the housing and out the other side until it
extends approximately 3 /4-inch from the end of the housing.
6.
Slide the cable tension clip (D) along the cable and insert into the housing (A), making sure that the large notch lines up with the large groove
on the inside of the connector housing (A). The cable tension clip (D) should slide easily into the housing until only 3 /8-inch of the cable
tension clip (D) extend from the back end of the connector.
