4211-195 05-22-12
Page 4
AI
SERIES STEAM BOILER WITH T100 CONTROL
INSTALLATION INSTRUCTIONS
SAVE THIS MANUAL
Thank you for purchasing your new Amerec steam boiler.
If we can be of any assistance do not hesitate to call our Technical Support department at 1-800-363-0251.
FOR THE SAFETY OF YOU AND YOUR FAMILY OR CUSTOMERS, PLEASE READ FOLLOWING WARNINGS AND ALL INSTRUCTIONS BEFORE
USING YOUR STEAMBATH. POST "STEAMBATH INSTRUCTIONS" LABEL OUTSIDE STEAMBATH FOR SAFETY WARNINGS.
WARNING
Electric Shock Hazard - High voltage exists within this equipment. Disconnect all electrical power before servicing the boiler. All installation and service
to this equipment should be performed by quali
fi
ed license personnel in accordance with local and national codes. There are no user serviceable parts
in this equipment.
Electrical grounding is required on all Amerec steambath boilers.
The boiler is designed for hookup with copper wire only, 75°C or better.
Wire the controls exactly as described. Do not connect any additional wiring or power supplies to the controls or their terminals in the boiler.
All plumbing must be installed by a licensed plumber in accordance with all applicable local and national codes.
Install indoors only. Protect from freezing. Boiler must be level side to side and end to end.
The pressure relief valve and generator drain must be installed in such a fashion that the risk of scalding is reduced to a minimum. Draining these
outlets into the steam room may present a scald hazard and may damage materials used to construct the room.
Be certain that steambath enclosures are properly sealed to avoid water damage from escaping steam. It is recommended that 100% silicone caulk be
used to seal all pipes and
fi
ttings. Steam must be prevented from escaping into the wall cavity.
Avoid traps and valleys in the steam line where water could collect and cause a steam blockage. The hot steam line must be insulated against acciden-
tal user contact.
Centering the steam pipe is critical in rooms made of plastic, acrylic, resin,
fi
berglass or similar materials. Allowing the steam pipe to touch materials not
rated 240°F (115°C) or higher will result in damage to these materials.
Do not install the steam head near bench(es) or where steam may spray or where condensation will drip on the user as this will present a scald hazard.
Be careful when entering a steambath. Escaping steam from an overheated steam room may cause injury.
Scald Hazard: Do Not Touch the steam head or trim during operation as they are HOT. Stay at least 12 inches (305 mm) away from the hot steam
escaping from the steam head.
Children should only use the steambath under close adult supervision.
Do not exceed 30 minutes in a steambath. Excessive exposure can be harmful to your health. Excessive exposure can produce a rapid pulse, light-
headedness, weakness or fainting. If you become uncomfortable or experience any of the above conditions exit the steambath immediately.
Steambaths can put undue stress on the body. Therefore a steambath should be used only under a doctor's direction if you:
Are in generally poor health
Are pregnant
Are under the care of a physician
Have a heart condition
Have circulatory problems
Have high blood pressure
Have
diabetes
Are
using
medication
DO NOT use the steam bath if you:
Are under the in
fl
uence of drugs
Are under the in
fl
uence of alcohol
