ACN-TL
Rev. 6.00
©2019, Ambient Recording GmbH
18
IR
Off
On
Legacy feature, pre ACN, only useful in combination with ACC501 controller. Enables the infrared port
above the OLED. Leaving the IR port open can compromise reliability of the unit in normal operation, so
only to be enabled through
“Extended”
mode.
Reset
Here you can restore the factory settings.
On ACN-ML(P) you have a wider selection of options:
↑
WiFi
Metadata
All
“
WiFi
”:
resets the devices SSID and password to ml(p/0)sssss, where “sssss” reflects the last 5 digits of
the serial number.
“
Metadata
”:
will keep all settings but purges the database. This may take up to 5 minutes.
“All”:
resets WiFi, database and local settings to factory defaults as marked bold in this description.
Info
DEV info
Debug1
Debug2
Screen test
First screen will show critical device information for serial number, firmware and FPGA software
revision, and MAC address, followed by 3 debug screens for developer use only.
9.
LED Blink Codes
Code Legend
●
flash (generator sync)
●●
double flash (low batt warning every 2 seconds)
●
●
double blink (active ACN transmission)
●
-
●
blink (generator free lock)
●
--
●
long blink (ACN reception)
Red: Generator Not Set, no ext TC present
Green: Generator Set, running ext/ACN TC detected
Orange / Red & green simultaneously: standing ext/ACN TC detected
Содержание TinyLockit ACN-TL
Страница 1: ...experience quality Lockit Timecode TinyLockit ACN TL Rev 6 00 ...
Страница 2: ......