Touch Screen Transmitter Manual Timer Instructions
Page:
20300538
INSTALLATIONS
Receiver
The remote receiver may be wall mounted or installed in the appliance per the appliance
homeowner’s manual.
Refer to the Homeowner’s Manual for special installation in-
structions.
If wall mounted, the remote receiver must be installed in a junction box with
cover plate provided. Failure to follow the installation instructions found in the appropriate
Homeowner’s Manual will void the warranty and may cause a fire hazard.
Installing Batteries
The remote receiver uses four (4) “AA” batteries. To install batteries,
1. Open the battery door by pressing the two tabs located on the door.
2. Install the batteries as indicated in the receiver cover.
3. Close the battery door until the door tab snaps in place.
4. To install the receiver into a wall junction box, snap wall cover plate to the receiver
and install the receiver with the screws provided to the junction box.
5. The batteries should be replaced at least once every 6 months or when the battery indicator flashes.
Connecting the Receiver to your appliance
This system comes with an 22 inch wire assembly. Insert the white terminal to the back of the receiver. The terminal
wire block can only be installed one way. Do not force the terminal plug onto the receiver.
Connect the wiring terminal two (2) 1/4” female spade terminals to the appliance. Refer to the appropriate Homeowner’s
Manual for proper wiring connections to the appliance. Your appliance may have other options to connect wiring from
receiver. Connect to the two (2) 1/4“ female spade wiring terminals. Wire can be no longer than 20 feet.
FP2603
receiver
FP2604
install batteries
Optional 6 hour Shutdown
1. The receiver comes preset from the factory with a 6 hour shutdown from its last ON operation. This is done to
prevent the appliance from continuing to run if unattended.
2. You may disable this feature if you wish. To disable, change the receiver privacy (DIP) switch #1
ONLY
to the
OFF position. Make sure the transmitter privacy (DIP) switches are set the same to the receiver. Follow the in-
structions on how to set the privacy (DIP) switch setting.
3.
By disabling this feature, your appliance may continue to run unattended.
FP2605
connect receiver
Receiver
mV valve
f i r e - p a r t s . c o m
