Touch Screen Transmitter Manual Timer Instructions
Page:
20300538
W
ARNING
Do not use two (2) or more remote control systems in the same area with the same
privacy code setting, as they will communicate with each other. This may cause the
appliances to malfunction.
Resetting the transmitter:
If the transmitter is not working properly, reinstall the batteries to reset the transmitter.
1. Pull out at least one of the batteries.
2. Press any key on the screen to discharge.
3. Wait for 10 seconds and then reinstall the batteries.
Pushing and holding any key for more than 10 seconds until the display refreshes will also reset the transmitter.
n
Functions and Operations
General:
The TSMT Remote Control has two (2) operating modes: Manual and Timer.
The transmitter will operate the remote receiver from 1 foot to a maximum of 30 feet. The distance is reduced when
batteries are low.
Manual Mode
In this mode, the TIMER button will only display “TIMER”, without showing the time. Pressing the
ON/up and OFF/down buttons will turn on and turn off the fireplace if the TIMER buttons isn’t pressed
and flashing.
1. Press the ON/up button to turn on the fireplace. The flame icon on the LCD displays High.
2. Press the OFF/down button to turn off the fireplace. The flame icon disappears.
3. Sliding up and down on the arrow buttons can also turn on or turn off the fireplace.
Timer Mode
Press the TIMER button to enter timer mode. The fireplace will stay on for a period of time as specified
by the timer and then be shut off by the transmitter when the timer counts down to zero.
1. When the TIMER button is pressed, the Set Time appears in the frame of the button and flashes.
2. Use ON and OFF arrows to increase or decrease the Set Time in 15 min increment, between 0:00 to
6:00. Slide up and down on the arrow buttons will increase or decrease the Set Time in 1 hour incre-
ment.
3. Push the TIMER button again to confirm the Set Time, the transmitter sends an ON signal to turn on
the fireplace.
4. The flashing stops and the ON/up and OFF/down buttons become flame controller again.
5. To exit Timer Mode,
a. Push and hold the TIMER button for 3 seconds Or
b. Press the OFF button Or
c. Use the OFF/down buttons to decrease the Set Time to zero.
FP2610
Manual mode
FP2611
timer mode
f i r e - p a r t s . c o m
