50D0111
RCSITEA Installation & Operating Manual
Rel 1.0 April 2009
Page 3 of 10
Ambient Technologies
A Division Of Monessen Hearth Systems
This system comes with an 22 inch two-wire assembly labled “FOR MILLVOLT VALVE ONLY, TP/TH” and an
10 inch four-wire assembly labeled “SIT VALVE ONLY”. Insert the white terminals into the back of the receiver.
The terminal wire blocks can only be installed one way and do not force the terminal plugs into the receiver.
Connect the wiring terminal two (2) ¼” female spade terminals to the appliance valve and four-pin connector to SIT
valve. Refer to the appropriate Homeowner’s Manual for proper wiring connections to the appliance. Your
appliance may have other options to connect wiring from receiver. For applications longer than 22 inches, use 18
gauge wire, 105ºC rated, with no splices. Connect to the two (2) 1/4“ female spade wiring terminals and wire can be
no longer than 20 feet.
WAR
N
ING
Speed control module and thermal sensor must be removed before installing receiver and
applying the AC power. Failure to do so may cause the part damage and void the warranty.
Without removing the control module and thermal sensor, they and RCSTEB both will try to
operate the blower at the same and may cause unexpected blower operation or damage.
Before connecting the blower with the receiver, always DISCONNECT SPEED CONTROL MODULE AND
THERMAL SENSOR from your fireplace if they exist as displayed in following diagram:
WA
R
N
IN
G
The blower has to be grounded to the body of the fireplace.
