*Netmask: 255.255.255.0 (Normally, this should not be changed) –
Remember 1 and 2 digit
subnet addresses have leading 0’s (.002. for .2. and .030. for .30).
1. Press [ENTER] – First digit is selected
2. Press [UP] or [DOWN] to change the digit to the desired value
3. Press [ENTER] when have the number you want (it will move to the next digit)
4. Press [UP] or [DOWN] to select next digit
5. Press [BACK] to go back to the previous digit to correct it, if necessary
6. Do this for all 12 digits, then press [ENTER] to save and return to the IP Address
submenu
*RpSrvr/LdSrvr: The eight server entries in this section reflect a mirrored server
configuration at the uplink sites with diverse Internet routes to each server. The report
servers 1-4 represent the reporting servers (were data and reports are sent). The load servers
1-4 represent the backfill servers.
The default IP addresses for each server is:
RpSrvr 1: 72.159.94.35
RpSrvr 2: 209.169.52.43
RpSrvr 3: 72.159.94.36
RpSrvr 4: 64.27.12.136
LdSrvr 1: 64.27.12.136
LdSrvr 2: 72.159.94.36
LdSrvr 3: 209.169.52.44
LdSrvr 4: 72.159.94.35
Changing the IP addresses for each server is the same. Scroll down to the server you want to
change and follow the instructions below.
1 and 2 digit subnet addresses have leading 0’s (.002. for .2. and .030. for .30).
1. Press [ENTER] – First digit is selected
2. Press [UP] or [DOWN] to change the digit to the desired value
3. Press [ENTER] when have the number you want (it will move to the next digit)
4. Press [UP] or [DOWN] to select next digit
5. Press [BACK] to go back to the previous digit to correct it, if necessary
6. Do this for all 12 digits, then press [ENTER] to save and return to the IP Address
submenu
Rev. 1 – Firmware version 2.03
28
©
2012
WARNING
Never change the IP addresses of the servers or the ports unless you are
instructed to do so by Amb-OS support personnel. Changing the ports can cause
the AMR-100-I to miss programs.