General safety instructions
Groundkeeper GH / HH SMARTCUT BAF0005.4 06.21
13
2.7
Safety measures in normal operation
Only operate the machine if all the safety and protection equipment is
fully functional.
Check the machine at least once a day for visible damage and check
the function of the safety and protection equipment.
2.8
Dangers from residual energy
Note that there may be residual mechanical, hydraulic, pneumatic and
electrical/electronic energy at the machine.
Take appropriate measures when instructing the operating personnel.
Detailed information is provided again in the various chapters of this
operating manual.
2.9
Maintenance and repair work, fault elimination
Carry out prescribed setting, maintenance and inspection work in a
timely manner.
Secure all media such as compressed air and the hydraulic system
against unintentional start-up.
Carefully fix and secure larger subassemblies to lifting gear when
carrying out replacement work.
Regularly check that bolted connections are firmly secured and tight-
en if necessary.
When the maintenance work is completed, check the function of the
safety devices
2.10
Constructive changes
You must not modify, add to or convert the machine without the con-
sent of AMAZONE. This also applies to welding work on load-bearing
parts.
Any addition or conversion measures require the written consent of
AMAZONE. Use only modification and accessory parts approved by
AMAZONE – this ensures (for example) that the operating permit
remains valid in accordance with national and international regula-
tions.
Vehicles with an official type approval or with equipment connected to
a vehicle with a valid type approval or approval for road transport
according to the German road traffic regulations must be in the state
specified by the approval.
