Amazone Catros 3001, Руководство по эксплуатации

Страница: 59 / 88

Coupling and uncoupling the machine
Catros BAG0053.14 10.17 59
WARNING
Risk of contusions, cutting, catching, drawing in and knocks
when the machine unexpectedly releases from the tractor!
•
Use the intended equipment to connect the tractor and the ma-
chine in the proper way.
•
When coupling the machine to the tractor's three-point hydraulic
system, ensure that the attachment categories of the tractor and
the machine are the same.
Be absolutely certain to upgrade the category II upper and lower
link pins of the machine to category III using reducing sleeves if
your tractor has a category III three-point linkage.
•
Only use the upper and lower link pins provided for coupling the
machine.
•
Visually check the upper and lower link pins for obvious defects
whenever the machine is coupled. Replace upper and lower link
pins if there are clear signs of wear.
•
Use a lynch pin on each of the upper and lower link pins in the
pivot points on the three-point frame attachment to secure them
against unintentional release.
WARNING
Risk of energy supply failure between the tractor and the ma-
chine through damaged power lines!
During coupling, check the course of the power lines. The power lines
•
must give slightly without tension, bending or rubbing on all
movements of the connected machine.
•
may not scour other parts.
1. Fasten the ball sleeves over the top link pins and fasten the
lower link pins in the pivot points of the three-point attachment
frame.
→
Be absolutely certain to upgrade the category II upper and lower
link pins of the machine to category III using reducing sleeves if
your tractor has a category III three-point linkage.
2. Secure the top link pins and lower link pins with clip pins against
unintentional release.
3. Direct people out of the danger area between the tractor and
machine before you approach the machine with the tractor.
4. First connect the supply lines before coupling the machine and
the tractor.
4.1 Drive the tractor up to the machine to leave a clearance of
approximately 25 cm between tractor and machine.
4.2 Secure the tractor against unintentional starting and unin-
tentional rolling away.
4.3 Connect the supply lines to the tractor.
4.4 Position the lower link hooks so that they are aligned with
the lower linking points on the machine.
5. Now, reverse the tractor all the way to the machine so that the
lower link hooks of the tractor automatically pick up the ball
sleeves of the lower attachment points of the machine.
→
The lower link hooks lock automatically.