Amate Audio DSP608, Руководство пользователя

Страница: 19 / 26

DSP608
– DSP608D
Jan 2017
19
Amate Audio
STANDBY: When this button is clicked, the DSP will go into standby mode (low
power consumption). In this mode, there is no output signal. Click the button again to
recover the normal operation mode.
EDIT: Open control window for full control of the device.
The following options are available in this window:

File / Quit : Close the program.

Tools
o
Change software password : allows the user to create a password to
access the software. By default, no passwrod is needed. If a password
is set and then forgotten, the software must be reinstalled.
o
New Group : create a group that associates 2 or more DSP.
o
Enter Demo Mode : enables to use the software without a connected
device.
o
Enable Update : Enables the firmware upgrade of the units in the list
(an Administrator password is required, see Section 8).

Help
o
Request Support : sends a report about a problem in the software,
o
About : Shows basic info about the application
6.2 Device Options
6.2.1 Main window
In this window the Preset options, the device name, and the input and output levels
and VUMeters, as well as the link and mute settings are displayed.
Here, also the source for In 3 & 4 can be selected. The available options are Analog,
AES Stereo, or Dante (only in DSP608D).
6.2.2 X-over window
In this window all the crossover settings for each output are displayed and can be
set.
The same information can be found on each channel’s window.