![background image](http://html1.mh-extra.com/html/amano/pioneer-eclipse-300bu/pioneer-eclipse-300bu_operators-manual_2918192012.webp)
12
Unpacking the Machine
The machine is shipped boxed on a wooden pallet. To
unpack machine:
1. Cut and remove bands holding the box to the pallet.
2. Remove staples attaching the box to the platform at
the bottom edge of the box.
3. With two people, one at either end of the box, lift box
straight up and off machine.
4. Cut and remove bands securing the machine to the
pallet.
5. Remove back brace.
6. Remove hex lock nut, bolt, and washer from handle.
7. Rotate handle to the user position to the top of the
adjustment slot. Then insert the bolt through the
handle bracket and handle top.
8. Place the washer and handle adjustment lever on the
bolt. Thread the adjustment lever in until it is against
the handle bracket, but do not tighten.
9. Adjust the handle to the desired height and tighten
the handle adjustment lever.
10. Check machine fluid levels (engine oil). See
Maintenance
section.
NOTE: If machine was shipped by airfreight, add
engine oil.
11. Carefully back the machine off of the pallet.
Filling the LP Cylinder
This machine uses the 20 lb (9.1 kg) capacity cylinder,
which meets the D.O.T. 4E240 standards. These
cylinders are also listed by UL. In addition, the steel
cylinder meets European TPED specifications and
is CE compliant. Filling should be done ONLY by a
qualified propane dealer. A properly filled cylinder
should not exceed 80% of the rated capacity. Do not
overfill the cylinder or use a liquid withdraw cylinder on
the machine. The use of a liquid withdraw cylinder on
a vapor withdraw system could freeze the regulator and
create a fire hazard.
Installing the LP Cylinder
Place the cylinder on the cylinder platform at the back
of the machine. Connect the fuel hose coupling to the
service valve by turning to the right (clockwise). HAND
TIGHTEN ONLY! Make sure coupling is not cross
threaded and check for leakage by noting any propane
odors immediately after cylinder is connected. Finally,
secure the tank to the machine using the adjustable
strap. Remove slack by pulling on the loose end and
securing with the Velcro.
TO REMOVE THE LP CYLINDER
, reverse the above
procedure. Always connect or change cylinders in a
well-ventilated area.
Machine Preparation
Содержание Pioneer Eclipse 300BU
