RS5290000 Rev. 0
6
April 1998
User Operation
Features
Spillsaver
ä
Shelves
Caution
To avoid personal injury or property damage, handle
tempered glass shelves carefully. Shelves may break
suddenly if nicked, scratched or exposed to sudden
temperature change.
1. Remove shelves by lifting front and releasing
hooks from metal track.
2. Replace shelves by inserting hooks into metal
track and lowering front.
Chiller Fresh System
Garden Fresh Crispers
Locate control on front trim to adjust to either high or low
settings.
1.
Remove drawers by lifting and pulling out.
Refer to "Spillsaver
ä
Shelves" for instructions
on removing and replacing shelf.
2.
Replace drawers by sliding in.
Locate control on front trim to adjust amount of air
circulating between drawer and sleeve.
1.
Remove drawer and sleeve by lifting and pulling
out.Refer to "Spillsaver
ä
Shelves" for
instructions on removing and replacing shelf.
Use eighth through eleventh slots.
2.
Replace sleeve then drawer by sliding in.
Confirm boot is over air inlet in side wall.
Beverage Chiller
Locate control dial on left front wall of Fresh Food
section to adjust amount of air.
1.
Remove beverage chiller door by
removing
lower door buckets. Slide chiller door down and
out through bottom of door track.
2.
Replace beverage chiller door by reversing step
1. Retention glides must remain in place to
install door.
Door Buckets
1.
Remove door buckets by pushing tabs toward
center and pulling out.
2.
Replace door buckets by sliding in until tabs lock
into place.
Door Shelves
1.
Remove slide-style door shelves by lifting
and pulling out.
2.
Replace slide-style door shelves by reversing
step 1.
1.
Remove hook-style door shelves by tapping up
each end. Lift bottom of shelf release hooks.
2.
Replace hook-style shelves by inserting hooks
and lowering bottom of shelf. Tap down on
ends.
Dairy Center
1.
Remove door by opening door, pushing in
slightly near hinges and pulling out.
2.
Remove shelf by lifting and pulling out.
3.
Replace door and shelf by reversing steps 1-2.
Snack Chiller
1.
Remove door by opening door, pushing in
slightly near hinges and pulling out.
2.
Remove bucket by removing Beverage Chiller
door then lifting bucket.
3.
Replace door and bucket by reversing steps 1-2.
Electrical Requirements
Refrigerator must be earthed and connected to a
separate 230 volt, 50 hz., 10A circuit.
Model Identification
Locate product information on the nameplate, found in
upper left corner of Fresh Food section. Record the
following information: Model Number, Manufacturing
Number, Serial or S/N Number, Date of purchase,
Dealer’s name and address.
Cold
Coldest
Low
High
