13
A
-
RS1300005 Rev. 0
Ice Storage Bin
The ice storage bin is located below the automatic
dispensing ice maker.
To remove and install ice storage bin:
• To remove bin, remove Quick Chill
Zone™. Raise ice maker
arm to deactivate ice maker.
• Lift front of bin and pull out to its full extension. Lift up
front of bin and remove.
• To install, slide bin into rails below ice maker until
bin locks into place. Drop ice maker arm to activate
ice maker, and replace Quick Chill Zone™.
IMPORTANT:
Ice bin must
be locked in proper place for
proper ice dispensing. If freezer
door does not close, bin is not
in proper location. Turn auger
driver as shown to properly align
ice bin with back of unit.
Freezer Features
Quick Chill Zone™
Quick Chill Zone™ provides a space for items to be
chilled or frozen quickly.
• To remove, lift Quick Chill
Zone™ from ice bin rails and
pull straight out.
• To install, reverse above
procedure.
Automatic Dispensing Ice Maker
This ice maker creates the ice used in the dispensing
system.
Using Ice Maker for the First Time
•
Confirm ice bin is in place
and ice maker arm is down.
•
After freezer section reaches
between 0° to 2°F (-18° to
-17° C), ice maker fills with
water and begins operating.
•
Allow approximately 24 hours
after installation to receive first harvest of ice.
•
Discard ice created within first 12 hours of
operation to verify system is flushed of impurities.
Operating Instructions
•
Confirm ice bin is in place and ice maker arm is
down.
•
After freezer section reaches 0°
to 2°F (-18° to -17° C), ice
maker fills with water and
begins operating. You will
have a complete harvest of
ice approximately every 3
hours.
•
Stop ice production by raising
ice maker arm until click is heard.
•
Ice maker will remain in the
off
position until arm is
pushed down.
Primary Features
CAUTION
!
To avoid property damage, observe the following:
• Do not force ice maker arm down or up.
• Do not place or store anything in ice storage bin.
WARNING
!
To avoid possible injury, including death, do not place glass items in Quick Chill Zone™. Glass objects may shatter or
explode if exposed to extreme cold.
This book is intended to show the variety of features that are available in the product
line. If your refrigerator does not have all the options that are shown, many of these
options may be purchased by contacting the Consumer Affairs Department. See contact
information on the cover of your manual.
What if These Features
are Different from Mine?
Содержание 22 Cu. Ft
Страница 48: ...1 A RS1300005 Rev 0 Appendix A...
Страница 72: ......