7
A
-
RS1300005 Rev. 0
Stainless Steel Models
Locate predrilled hole at
base of handle, and fit
hollow end of handle
over lower door clip.
2
Fit other end of handle over
upper door clip and slide
up as far as possible.
3
Loosen lower door clip on
refrigerator door with
1
/
4
"
hex nut driver.
1
Insert
1
/
4
" hex nut driver
into predrilled hole at base
of handle and tighten screw.
4
Insert screw plug into
predrilled hole, as
illustrated.
5
Repeat steps 2 through 5 to install
freezer handle.
6
To remove after initial install...
•
Follow steps 2 through 5 in reverse order.
IMPORTANT:
To avoid damage to unit, use
a flat blade screwdriver edge wrapped in
masking tape to remove screw plugs.
Installing Your Refrigerator
How to Install the Handles
continued
How to Connect the Water Supply
WARNING
!
To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before
connecting water supply. After connecting water supply, connect power.
CAUTION
!
To avoid property damage, observe the following:
• Consult a plumber to connect copper tubing to household plumbing to assure compliance with local codes and
ordinances.
• Confirm water pressure to water valve is between 20 and 100 pounds per square inch. If water filter is installed, water
pressure to water valve must be a minimum of 35 pounds per square inch.
• DO NOT use a self-piercing, or
3
/
16
" (4.8 mm) saddle valve. Both reduce water flow, become clogged with time, and may
cause leaks if repair is attempted.
• Tighten nuts by hand to prevent cross threading. Finish tightening nuts with pliers and wrenches. Do not overtighten.
• Wait 24 hours before placing unit into final position to check and correct any water leaks.
Materials Needed
•
1
/
4
" (6 mm) outer diameter flexible copper tubing
Remove plastic cap (A) from
water valve inlet port (B).
1
Place brass nut and sleeve on copper tube
end and insert tube into valve inlet port.
•
Attach nut on copper tubing to valve inlet port.
2
NOTE:
Add 8' (2 m) to tubing length needed to reach water
supply for creation of service loop.
• Brass nut and sleeve (see literature pack)
• Shut-off valve (requires a
1
/
4
" or 6 mm hole to be drilled
into water supply before valve attachment)
• Adjustable wrench
NOTE:
If top of handle does not fit over top
clip, loosen lower clip further until fit can be
accomplished.
A
B
Содержание 22 Cu. Ft
Страница 48: ...1 A RS1300005 Rev 0 Appendix A...
Страница 72: ......
