RS1300005 Rev. 0
36
Ice ‘N Water Systems
Troubleshooting of 5 button electronic Ice ‘N Water dispenser
Dispenser Operation
Select
WATER
,
CRUSHED
or
CUBED
mode by pushing the button on the dispenser panel. A green indicator light
above the button indicates the current selection. Selection mode cannot be changed from
CRUSHED
to
CUBED
or
from
CUBED
to
CRUSHED
while ice dispenser is in operation.
Dispenser Light
Light activates at full power when dispensing ice or water. A sensor activates light at half-power when light level
around refrigerator is low. Activate or deactivate sensor by pushing
AUTO
LIGHT
button located on control façade.
Green light above
AUTO
LIGHT
button indicates sensor is active.
Dispenser Lock
Prevents operation of water and ice dispensers. To activate or deactivate lock, press and hold
DISPENSER
LOCK
button for 3 seconds. Green light above button indicates dispenser lock.
Automatic Lock Out
Shuts down both ice and water mechanisms of dispenser when either mechanism has run continuously for 5
minutes. To return power to dispenser, press and hold
DISPENSER
LOCK
for 3 seconds. Auger motor shuts off
automatically after 3 minutes of continuous operation. After about 3 minutes in shut-off state, auger motor
resets automatically.
Filter Status Light
This feature reminds users to replace water filter after 6 months have passed or after 500 gallons of water are
filtered, whichever happens first.
NOTE: Filter status light turns red after 6 months have passed or after 500 gallons of water are dispensed,
even if bypass is installed and unit is used without filter cartridge.
Green light indicates filter in good condition. Red light indicates filter replacement needed.
The filter monitor works by keeping track of time:
•
Six months is approximately 16 million seconds.
•
The refrigerator’s water system requires about 53,000 seconds to pass 500 gallons of water.
•
Each second that water is dispensed counts as 1.20 ounces of water.
•
An additional 3.20 ounces of water is counted every 30 minutes. This attempts to account for ice usage.
Filter Status Light Reset
Once filter light turns red, it remains red until reset. To reset filter indicator, press both
DISPENSER
LOCK
and
WATER
pushbuttons simultaneously and hold for 4 seconds. Make sure green light flashes 3 times when indicator
resets.
Содержание 22 Cu. Ft
Страница 48: ...1 A RS1300005 Rev 0 Appendix A...
Страница 72: ......