return to "Load model".
9.4 Rudder servo type selection
When the screen shows "Load model", press the DOWN/DATA- key to display "Tail servo type", and then
press enter to select it.
There are five types of servos to choose from:
◆
"1520us 72Hz" all the servos are analog servos
◆
"1520us 250Hz" broadband digital rudder servo is a servo (Futaba S9253, S9254, S9257, etc. and some of
the common digital servos). Main rotor servos are analog servos
◆
"1520us 333Hz" broadband digital rudder servo is a servo (Futaba S9253, S9254, S9257, etc.). Main rotor
servos are broadband digital servos
◆
"760us 400Hz" rudder servo is a narrowband digital servos (Futaba S9251, S9256, BLS251, MKS DS8910,
BLS980). Main rotor servos are broadband digital servos
◆
"960us 333Hz" rudder servo is a digital servo (LogicTech6100G, 3100G, Hitec5083MG). Main rotor servos
are broadband servos
Use the UP/DATA+ or DOWN/DATA- keys to select the required servo type. When finished, press the BACK
key to return to "Tail servo type".
9.5 Model type selection (helicopter swashplate type selection)
When the screen shows "Tail servo type", press DOWN/DATA- key to display "Model type", and then press
ENTER to select it.
There are five swashplate types to choose from: "Heli 120", "Heli 135", "Heli 140", "Heli 90" & "Heli Normal".
These are shown earlier in the manual. For example, for helicopters with 120 degree CCPM, select "Heli 120".
Use the UP/DATA+ or DOWN/DATA- keys to select the required swashplate type. When finished, press the
BACK key to return to "Model type".
You can now connect the servos to the gyro, but do not install the servo arms.
9.6 Servo tuning
When the screen shows "Model type" press DOWN/DATA- key to display "Servo trim", and then press ENTER
to select it.
Switch the gyro mode switch, setup earlier, several times quickly, to re-initialize the gyro, and then leave the
switch is the non locked tail mode (rate). Set all transmitter sticks to the center position. Now fit the servo
arms.