A gyro mode switch should be setup in the transmitter to change between locked tail and non lock tail mode.
The following table is a list of major transmitter brands showing the suggested values that should be uses.
After transmitter setup, set the switch to the tail locked mode position. After the "G:" an "A" should be
displayed. Toggle the switch to the non-locked mode position, it should show "N", if setup correctly. It is
recommended to initially set the transmitter so that the display shows a gain value close to 36. This can be
adjusted later after the tail behavior has been monitored during flight.
When finished, press the BACK key to return to "Monitor".
9.2 Gyro installation position selection
When the screen shows "Monitor", press the DOWN/DATA- key to display "Installation Direction", and then
press ENTER to select it.
Select one of the three orientation modes for the gyro (shown earlier in the manual), to match the actual
installation in the helicopter. When finished, press the BACK key to return to "Installation Direction".
9.3 Download model data stored in the programmer to the gyro
When the screen shows "Installation Direction", press the DOWN/DATA- key to display "Load model". Press
ENTER, then press UP/DATA+ or DOWN/DATA- keys to select one of the ten models, in which 1-5 are a
factory pre-existing set of model parameters, and 6-10 are reserved for 5 sets of user's own parameters (see
instructions on using the programmer's Model save and Model rename, in the Advanced menu). It is
recommended to starting with model parameters 1-5. Select the desired feel you require, for example
"Beginner", “F-3C”, “Soft 3D” etc.
When you have selected the model data to download, press ENTER. The following menu will appear on the
display.
When the "Yes" is flashing, press the UP/DATA+ key next to the “Yes”. The selected model data will be read
from the programmer and sent out to the gyro. When the download is complete, press the BACK key twice to