Alvarion BreezeACCESS EZ AU-EZ, Системное руководство

Страница: 45 / 175

Chapter 3 - Commissioning Configuring Basic Parameters
BreezeACCESS EZ AU-EZ 26 System Manual
3.1 Configuring Basic Parameters
3.1.1 Initial Configuration
After completing the installation process, as described in the preceding chapter,
the basic parameters must be configured to ensure that the unit operates
correctly. After the basic parameters have been configured, additional parameters
can be remotely configured via the Ethernet port or the wireless link using Telnet
or SNMP management, or by loading a configuration file.
Refer to Section 4.1 for information on how to access the Monitor program using
Telnet and how to use it.
The Basic Configuration menu includes all the parameters necessary for the
initial installation and operation of the Access Units. In many installations, most
of these parameters should not be changed from their default values. The basic
parameters and their default values are listed in
Table 3-1 .
Refer to Chapter 4 for detailed information on the applicable parameters.
Table 3-1: AU-EZ Basic Parameters
Parameter Default Value Comment
IP Address 10.0.0.1
Subnet Mask 255.0.0.0
Default Gateway Address 0.0.0.0
DHCP Options Disable In DHCP Client
Access to DHCP From Ethernet Only In DHCP Client
ESSID ESSID1
Select Country Code Depends on factory
configuration In Country Code Parameters.
Applicable only for 5.4 and 5.8
GHz units. See
Section 3.1.2
below.
Frequency The lowest frequency
in the sub band In Frequency Definition
DFS Required By Regulations
(if DFS is supported by Country
Code) Depends on Country
Code In Frequency Definition > DFS
Parameters
Frequency Subset Definition All frequencies In Frequency Definition > DFS
Parameters. Applicable only if
DFS is enabled