SMS Status Messages:
HEATER
ON 30min
-
heater status and time until switching off
GSM (0-31): 28
-
GSM receive signal level (not less than 10)
Voltage: 12.8
V
-
car-system voltage
Output
:
off
-
auxiliary output OUT status
Specifications
LED
GSM-
antenna
(
adhesive tape
)
GPS-
antenna
(
magnet
)
LED status
(in SIM card slot)
Solid - request to SIM card, searching for network connection
Slow blinking (once every 2 seconds) - waiting mode
Fast blinking (5 times every second) - establishing of GPRS/RING/SMS/USSD
Installing a Button to Switch on the Module
Make a
Ø8
mm
hole in the plug or in another easily accessible for a driver
place. The button is connected in accordance with the color of the main
connector wires (key: Input IN - +12V, LED: output AN - resistor - +12V).
Note: if a non-latching button (FIXKEY1 setting) is used to switch heater on
heater will not be switched off
automatically
after time specified in TIME1
.
General Information
Dear buyers of ALTOX equipment!
We thank you for purchasing a new ALTOX GSM-4 GPS device. This device
will provide you with great options to control your autonomous starting
parking heater.
You need a SIM card for your ALTOX device. It is recommended to use
special plans for M2M equipment.
Use
Using ALTOX system you can control your starting parking heater remotely
using a phone. ALTOX GSM-4 GPS device is equipped with in-built GPS-
GLONASS module which allows controlling the vehicle's location via a text
message (SMS), ALTOX HEATER mobile Internet app and via ALTOX SERVER
2.0 monitoring system in the real-time mode (TRACKING1 setting).
Control and Programming
You can start using your ALTOX module right after you have saved
authorized phone numbers in settings (3 cells: NUM1 / NUM2 / NUM3).
Saving of the first caller's phone number into cell NUM1 follows up
automatically (cell NUM1 should be empty).
To save other phone numbers use a text message instruction
NUMX:+YYYYYYY, where X is a number from 1 to 3, and +YYYYYYY is a
phone number.
To clear the cell send NUMX instruction without specifying a phone number.
There are the following control options:
- Outgoing voice call and DTMF commands;
- Outgoing text messages (SMS instructions);
- Mobile applications Thermo Call, HeaterRC or others;
- Direct control via a button in the car's interior;
- Via web interface of the mobile Internet app http://
altox.
ru
/
app
Управление исходящим вызовом
Call the phone number of the SIM card installed in the GSM module. The
phone number you are using to make a call should already be saved in the
device (see text messages
SMS-commands
). If the call is made using a
number that has not been saved in the ALTOX module, the connection with
the device will end without receiving a response signal. The working status
of the heater will not change.
If this setting is not active (CALL0), the call is dropped after a certain
number of ringing tones.
1 ringing tone - the heater switches on,
2 ringing tones - the heater switches off.
Red - Power 12V (via fuse 1А)
Black - GND (Common)
Pink
-
Input IN (connection of the button)
Blue
-
Analog output AN (commutates at GND)
Grey
-
Auxiliary output OUT (commutates at GND)
Please deactivate PIN code request
before inserting a SIM Card!
Parameter
Value
Power Supply Voltage
10
V
- 28
V
Standby Current
less than 35mA
Max Current for Auxiliary Output Terminals
15
0
mA
Operating Temperature
from
-40
to
+80°С