14
•
Green control lamp
lights up.
(Fig. D/13)
SWITCHING ON
BRUSHING VACUUM
CLEANER KSP 770/970:
•
Insert key.
(Fig. C/9)
•
Open fuel cock.
(Fig. C/8)
•
All control levers not
actuated.
•
Turn key-operated
switch into position ‘I’.
•
Push choke lever into
‘Choke’ position.
(Fig. C/6)
•
Pull reversing starter.
(Fig. C/7)
•
If motor starts, push
choke lever into
‘RUN’ position.
PUTTING INTO
OPERATION
•
Lower side brush.
Move lever into
horizontal position.
(Fig. B/2)
•
Adjust brush roller
pressure on hand
wheel.
(Fig. E/16)
•
Start engine and let
the brush roller
rotate for a short
time at a standstill.
•
Raise the machine
slightly at the front
and pull it back.
With a correct setting a
parallel running
sweeping line with a
width of 4 - 5 cm is
obtained on the ground.
•
Turn hand wheel to
the right = brush
roller pressure low.
•
Turn hand wheel to
the left = brush roller
pressure high.
•
Release parking
brake.
(Fig. E/15)
•
Pull throttle lever to
the thrust yoke =
drive coupled.
•
Throttle lever not
actuated = drive
uncoupled.
(Fig. B/1)
AFTER THE END OF
WORK
•
Lock parking brake.
(Fig. E/15)
•
Raise side brush.
Place lever in an
upright position.
(Fig. B/2)
•
Turn key-operated
switch into position
‘0’
.
•
Remove key.
KSP 770/970:
•
Close fuel cock.
EMPTYING DIRT TANK
•
Push lever for dirt
tank to the right.
(Fig. C/3)
•
Pull dirt tank
downwards and out
and empty it.
•
Insert dirt tank again
until it clicks audibly
into place.
MAINTENANCE WORK
For servicing and
maintenance work for
the combustion
engine please see its
operation manual!
Please carry out the
listed maintenance work
as follows:
daily:
•
empty dirt tank
KSP 770/970:
•
check oil level
