Alto 120V, Руководство оператора

Страница: 22 / 36

Page - 22 - CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher
HOW TO CORRECT PROBLEMS IN THE MACHINE
The machine will not run. The machine may not have Make sure the machine is connected to
any power. the correct voltage and frequency and
that all connections are tight or,
Make sure the machine is plugged in.
The power cord may be
damaged.
Contact an authorized service person
There is too much pad pressure. Decrease the pad pressure
The pad is worn or dirty. Clean the pad. If the pad is worn, replace it.
The pressure gauge There is too much pad pressure. Decrease the pad pressure.
indicator stays in the
red area.
There is too much pad pressure. Decrease the pad pressure.
The main switch is defective. Contact an authorized service person.
The circuit breaker is defective. Contact an authorized service person.
The machine will not The machine may have no power. Make sure the machine is connected to
start . the correct voltage and frequency and
that all connections are tight or,
Make sure the machine is plugged in.
The pressure gauge The pad pressure needs Verify a pad is on the machine.
indicator stays in the adjusting.
white area. Increase the pad pressure.
The brush warning light The carbon brushes need
illuminates. replacing. Contact an authorized service person.
The machine is vibrating The pad is not installed Remove the pad. Install the pad correctly.
excessively. correctly.
Center the pad properly.
The pad is worn or damaged. Install a new pad.
The pad is defective. Inspect and install a new pad.
Action Cause
Problem