Page 7
Work Light II
Installation & Users Manual
Mounting
The LED Work Light is simple to install and position where work lighting is needed. The unit is supplied
with a C-Clamp, Diffuser Frame, and Safety Cable. When mounting the LED Work Light, you must follow
all national and local codes for safe installation and use. Unit weight, with accessories is 11 pounds / 4.98
kilograms.
Adjusting Tilt
The LED Work Light can have its tilt adjusted via the two lock off handles on each side of the luminaire
(refer to Figure 1). Simple loosen (but DO NOT REMOVE) each handle so the unit is able to swing up and
down. Set tilt as desired and re-tighten the two lock off handles so the unit does not move from the set
position.
Luminaire Yoke Assembly
Safety Cable Anchor Point
Hinged Accessory Door
(Diffuser Frame supplied with unit)
Tilt Lock Off
Handle (x2)
Figure 1: LED Work Light Features
Local Dim Switch
PowerCon Input
PowerCon Thru / Out
C-Clamp
