OPERATION AND PROGRAMMING - DIMMING CURVE AND DMX TERMINATION
PEGASUS 6” and 8” Fresnel Installation
&
User’s
Manual
PAGE 13
DIMMING CURVE:
Pegasus will replicate one of three programmed dimming curves replicating linear and incandescent dim-
ming.
SETTING
DISPLAY [RDM]
DESCRIPTION
601
P01 [0]
Linear
602
P02 [1]
Incandescent Fade 1
604
P03 [2]
Incandescent Fade 2 (fast Bottom)
SETTING DIM CURVE:
1. Wait for Display to go blank (decimal points may still be active depending upon termination and
DMX presence.
2. Using the programming buttons set the desired DIMMING CURVE setting
3. Wait 2 seconds, the display will then will change the [ HUNDREDS ] digit to a [P],
asking for confirmation of personality change.
4. Depress the [ ONES ] button to confirm personality change Pressing any other button reverts
back to 60X series display so that modification can be made.
5. Depress the [ONES] button a second time to return out of programming mode.
DMX TERMINATION:
Pegasus is supplied with a programmable DMX terminator built into the luminaire. In a DMX system it
is recommended that the luminaire that is at the end of the DMX Daisy-chain is terminated using a 120
OHM resistor.
SETTING
DISPLAY [RDM]
DESCRIPTION
998
I---I [0]
Termination ON
999
---- [1]
Termination OFF
SETTING DMX TERMINATION:
1. Wait for Display to go blank (decimal points may still be active depending upon termination and
DMX presence.
2. Using the programming buttons set the desired DMX TERMINATION setting
3. Wait 2 seconds, the display will then will change the [ HUNDREDS ] digit to a [P],
asking for confirmation of personality change.
4. Depress the [ ONES ] button to confirm personality change Pressing any other button reverts
back to 90X series display so that modification can be made.
5. Depress the [ONES] button a second time to return out of programming mode.
