OPERATION AND PROGRAMMING -DMX CONTROL MODE
PEGASUS 6” and 8” Fresnel
Installation
&
User’s
Manual
NOTE: upon loss of valid DMX setting 904 will initiate an instant change in the light output from the DMX set-
ting to FULL ON (100%)
When this is done, after 2 sec, the display will change the [ HUNDREDS ] digit to [P],
asking for confirmation of personality change. This is confirmed with a press of [ ONES ] button. Pressing any
other button reverts back to 90X series display so that modification can be made.
Once confirmation is made:
Display blinks and shows new Absence of DMX setting
(oFF, HLd, PrE, FuL) for 4 sec, then goes to current mode display.
Locked State:
When in Locked State, Buttons will have no effect until they are unlocked. To Lock (or unlock) the buttons, do
the following button sequence:
Wait a few seconds until the display goes blank,
1.
press and hold the [ ONES ] button,
2.
press and hold the [ HUNDREDS ] button,
3.
release the [ ONES ] button,
4.
release the [ HUNDREDS ] button.
Display will blink and show Loc (or unL) for 4 sec and then go to current mode display.
[ Default is unlocked]
*Display Notes:
Display goes completely blank after 4 seconds, except :
1. If in DMX Mode and DMX signal is detected;
then: [ONES] decimal point will stay lit
2.
If
in
Standalone
Mode,
and
Receive
State;
then: [TENS] and [ONES] decimal point will stay lit;
3. If in Standalone Mode, and Control State;
then: [HUNDREDS], [TENS] and [ONES] decimal
point will stay lit.
SETTING
DISPLAY [RDM]
DESCRIPTION
901
oFF [00]
off (dimmed to 0%) [Default]
902
HLd [01]
hold last look (retains last DMX level)
903
PrE [02]
preset (Standalone Preset level
904
FuL [03]
full on (100%)
Absence of DMX:
When connected to a DMX network, if there is a loss of signal the following settings will effect the behavior
of the Pegaus Luminaire upon signal loss. This mode can be programmed by entering a number greater
than 900. There are four (4) different options upon the loss of signal.
PAGE 12
HUNDREDS
Decimal Point
ONES
Decimal Point
TENS
Decimal Point
