2
INTRODUCTION
You have just bought the outdoor siren self-powered
SIREX
of the range
ALTEC
. Many thanks.
Designed
to last, Sirex comes in a moulded case made of cast aluminium with polyester paint to the
test of time.
SIREX-F
includes an alarm light with LED technology ultra
high brightness, which in addition to a high resistance to
vibration and extreme temperatures offers a lifetime much
superior to traditional solutions.
1-
Support for backup battery
2-
Opening tamper
3-
Interrupters of configuration
4-
Flash with leds!!!
WARNING!!!
: Leds are type ultra
high brightness. Do not face.
5-
Sensor for removal tamper
6-
Running cables
SIREX has a double load regulation for the internal
battery:
- Regulation of charging current to 100 mA
, sufficient to charge the internal battery normally.
In alarm, only the internal battery is required. This effectively protects the charger of the panel
when several sirens are powered by it.
- Regulation of charging to 13.8 Vdc:
Even if the charging voltage delivered by the panel is not
high enough, Sirex amplifies it to provide to the battery a charging voltage of 13.8 Vdc to warranty a
perfect load.
WIRING
•
Before wiring the auto-protection, make sure that the circuit does not exceed
60VDC/0,1A.
•
The supply terminal « +12V DIR » can be used to provide the required current to
operate the SIREX even in the absence or failure of the backup battery. However, there
should be provided a source of high capacity and protected against over current that
can be caused by a defective backup battery.
•
The power of SIREX through the terminal « +12V CHR » is the recommended method
because the backup battery has a constant load with a current limit at 100mA and a
voltage regulator at 13.8Vdc. In alarm, only the internal battery is sought and protects
effectively the charger of the panel.
•
If the equipment that drives the Sirex is not the one who provides the current, you have to
connect the terminal
« 0V »
to this equipment to obtain a common reference.
•
The blocking or the resetting of the Sirex is driven by a positive control voltage of 9 to 16V
continuous on the input
« SIR ».
•
The terminal « I / O » allows the placing of signs ON or OFF of the alarm system by a
blocking voltage between 9 and 16VDC.
