Altai Technologies Ltd. All rights reserved
C1n Series WIFI AP/CPE Web-admin Configuration Manual
TPS15-003_rev1.3
VLAN Pass Through
: Configure the WLAN that acts as VLAN truck port. This option is
available if user enables VLAN. If user specifies a WLAN as VLAN pass through, C1n
does not modify the incoming packets that are tagged. Also, C1n tags the packets,
which are not tagged, with native VLAN ID if Native VLAN Tagging is enabled.
VLAN TagId
: Specify the VLAN ID of WLAN; this option is available if user enables VLAN.
If user specifies a VLAN ID, C1n tags all incoming packets from the radio with VLAN ID,
and then forwards them out.
Hide SSID
: Specify whether C1n broadcasts this SSID or not. If checked, C1n will not
broadcast such SSID.
SSID
：
Specify SSID of each WLAN; it supports up to 32 characters. The default SSID is
Superwifi Network X, where X is WLAN number.
Enable Intra-WLAN User Isolation
: Allow or block intra-WLAN user communication. If
enabled, clients cannot communicate to each other directly in the same WLAN. By
default, it is enabled. By default, it is enabled.
Allow DHCP Snooping Trusted Port
: DHCP snooping prevents illegal DHCP servers from
offering IP address on untrusted wireless port.
Access Traffic Right
: Specify AP management privilege of associated client; there are
3 options: “Full Access”, “AP Management Only”, and “AP Management Disable”.
Max Clients
: Specify maximum associated clients of each WLAN. The default value is
256.
Station Association Requirement
Reject Station Association if SNR less than X
: Set the minimum signal value X(SNR) for
client can associate to this WLAN. When a client’s SNR lower than X, This client can’t
associate to this WLAN, The range is 0~100dB, and 0 means disable.
Disassociate Station if SNR drops more than Y dB for consecutive Z packets
: Set the
signal threshold value Y(SNR) and the packet threshold value Z. When a client’s SNR is
lower than Y and loose Z packets consecutively, this client will be disassociated from
Radio0.
Back to WLAN List
: Go back to previous page
Configure a WLAN in Radio0:
1.
Select
Configuration
Wireless
Radio0
WLAN
to click “
More…
” behind the
WLAN, and then select
WLAN General
.
2.
Check
Enable WLAN
3.
Enable VLAN pass through in
VLAN Pass Through
or set VLAN ID in
VLAN TagId
if
necessary.
4.
Specify whether Radio0 broadcasts this SSID.
5.
Specify SSID in
SSID
6.
Enable
Intra-WLAN User Isolation
if necessary.
7.
Select WLAN’s Access Traffic Right.
8.
Set the maximum number of users this WLAN serves in
Max Clients
9.
Set the values in
Reject Station Association if SNR less than X
,
Disassociate Station
if SNR drops more than Y
, and
for consecutive Z packets
if necessary.
